Rods & Mortar Installation System

Our online store can help calculate the parts you will need to build your Easifix or Rods & Mortar kit
DIY Kits
Rods & Mortar How to Install
Easifix How to Install
Buy a Rods & Mortar DIY Kit from the Glass Block Outlet online store


Step 1 - Preparing of the opening Step 1
Calculate the correct opening size. Make sure the opening is square and perpendicular. Lay bitumen expansion material along base of opening. Secure expansion foam to jambs and head. All four sides of the opening should now be covered in expansion material (See fig.1). Bitumen is necessary on the base to take the weight of the glass block wall.

Step 2 - Preparing of the opening Step 2
Set out dry your first row of glass blocks to ensure opening size is correct. Mark accurately and drill oversized holes in between the blocks, vertically and horizontally where rods will be positioned. Fill holes with silicon and fit vertical bars in place (fig.2).

Step 3 - Laying first course Step 3
Mix Colmef Vetromix glass block mortar following instructions on reverse of bag (fig.3). The mix should be a semi dry consistency (Slump 1 or less). Lay down abed of mortar.

Step 4 - Laying first course Step 4
Fit first block and tamp down gently, fit second block and repeat. Ensure there is enough mortar between the blocks and the base to create sufficient adhesion, compact the vertical mortar joint using a wooden instrument. (fig.4) Note: Spacer pegs are not required between base and first row of blocks.

Step 5 - Building the panel Step 5
Repeat Step 4 until you have completed the first row. Insert spacer pegs in between blocks, this prevents steel rods from touching glass (fig.5). Lay half the quantity of mortar and fix the horizontal rod in position, not forgetting to put silicon in the holes, then cover over the rod with remainder of mortar (fig.6). Rods have to be positioned every row vertically and horizontally. If using a ‘U’ channel, two stainless steel reinforcement rods are required around the perimeter.

Step 6 - Building the panel Step 6
Fit next row, checking vertical and horizontal alignment.

Step 7 - Finishing the glass block panel Step 7
When the wall has set, snap off spacer tabs and grout all joints with diluted Colmef mortar.

Step 8 - Sealing and waterproofing the glass block panel Step 8
Mastic around perimeter of expansion foam to create a weather proof seal.